DJ-X11T

$339.00
Out of stock
 

The Alinco DJ-X11T wideband receiver covers 50 kHz to 1299.995 MHz (less cellular) in AM, FM wide, FM narrow, SSB and CW modes. The illuminated LCD display supports two lines. In addition to frequency information, it will also show the operating mode, memory channel, battery strength, signal strength and a number of other user-selected operating parameters. The keypad is backlit. Six types of memory banks are supported.

The DJ-X11T even supports dual frequency simultaneous reception giving you the ability to concurrently listen with the main band and sub band (with some frequency limitations). Please note that sub band coverage is 118-174 MHz and 336-470 MHz. The F tuning function allows you to automatically tune very strong, nearby signals. The built in MW ferrite bar antennas provides good AM band reception

ALINCO DJ-X11T Features
  • 2VFO simultaneous RX
  • Main-band coverage: 50KHz - 1,299.99995MHz all mode AM/FM/WFM/SSB/CW (BFO for SSB/CW receive. An external antenna required for practical HF monitoring. Internal bar antenna for AM broadcast reception and earphone antenna feature inclusive.)
  • Sub-band coverage: VHF:118 - 171MHz/UHF:336 - 470MHz in AM/NFM
  • 1200 memory channels with adjustable memory banks using utility freeware (optional PC cable required)
  • IQ signal and Discriminator output features: DJ-X11 has an IQ signal output that can be used with 3rd-party software to operate as a SDR. 10.7MHz IF discriminator signal can be used with other receiver-related software available on the net such as AIS-plotting.
  • Voice-guidance system reads entering/entered frequency in English
  • Easy-to-use twin dials
  • Pocket size unit measures 61 (W) x 106 (H) x 38 (D) mm / 2.4 (W) x 4.17 (H) x 1.50 (D) in (without projections)
  • Rigged Polycarbonate body with rubber protectors
  • Selectable tuning steps: 0.05/0.1/1/5/6.25/8.33/9/10/12.5/15/20/25/30/50/100/125/150/200/500kHz/1MHz
  • Various scan modes: Preset, programmed, memory, VFO and tone scan
  • 3 selectable scan speeds (VFO: 25ch/s, 33ch/s, 100ch/s, Memory: 4.5ch/s, 8.3ch/s, 20ch/s)
  • TSQ and DCS decode
  • Wire remote-control using optional EDS-12
  • Long-lasting 1800mAh Li-Ion battery pack provides nearly 15 hours of operation at full audio output in a single RX mode
  • 1200 Alphanumeric (up to 16 characters) memory channels
  • Additional 100 memory channels are available for each Dual-mode memory, Search-pass, Priority monitoring and Programmed Scanning pairs
  • Large, brightly illuminated full dot-matrix LCD and keypads
  • Dual channel-scope (Alinco's patented spectrum analyzer-like feature)
  • Frequency counter and flash tune
  • "Bug detector" function searches for hidden transmitters
  • Illuminated keypad for comfortable operation
  • Standard Drop-in charger fully charges empty EBP-74 in 4 hours
  • RF gain and attenuator for both main/sub VFOs
  • Analog inversion-scramble decoder***
SPECIFICATIONS
Receiver Range Main VFO 0.05 - 1299.99995 MHz in All available modes / Sub VFO 118 - 170.995MHz & 336 - 469.995MHz in AM/FM (Cellular frequencies 824.000 - 849.995MHz, 869.000 - 894.995MHz blocked on T models. EGR model receives Ham and Broadcast bands only. 225 - 335.995 MHz in AM/FM may be usable although out of specification and warranty)
Mode FM,WFM,AM,SSB(USB/LSB),CW(CU/CL)
Antenna Impedance 50 ohms (SMA)
Supply Voltage DC 3.7V (EBP-74) / DC 4.5V (EDH-33) / DC 5.4V - 6.0V (external regulated source) negative ground
Current consumption approx.130mA Mono band / 180mA Dual band
Temperature Range -10 to +60 dig C (+14 to +140 dig F)
Frequency Stability -7 to +3ppm(-10 to +60 dig C)(+14 to +140 dig F)
Dimension without projection 61 (W) x 106 (H) x 38 (D) mm / 2.4 (W) x 4.17 (H) x 1.50 (D)
Weight Approx.235g / 8.29 oz (Ant.& EBP-74 inclusive)
RECEIVER
Receive circuitry Triple-conversion super heterodyne AM/SSB/CW/FM in Main VFO / Double-conversion super heterodyne AM/FM in Sub VFO and WFM in Main VFO
Sensitivity 10dB S/N:AM/SSB/CW , 12dBSINAD:FM/WFM)
Selectivity SSB/CW -6dB: 2kHz or more -50dB : 7.5kHz or less, AM/FM -6dB : 12kHz or more -60dB : 35kHz or less, WFM -6dB : 180kHz }40kHz -20dB : 470kHz or less
Main Band 0.050~0.531MHz (AM) 5dBu 0.531~1.62MHz (AM) 2dBu 1.62~76MHz (AM) -5dBu 1.62~76MHz (SSB,CW) -10dBu 1.62~76MHz (FM) -15dBu 76~108MHz (WFM) -3dBu 108~136MHz (AM) -6dBu 136~174MHz (FM) -14dBu 175~221.75MHz (WFM) -6dBu 221.8~336MHz (AM) 0dBu 336~475.75MHz (FM) -13dBu 475.75~770MHz (WFM) -13dBu 770~1260MHz (FM) -9dBu 1260~1300MHz (FM) -6dBu
Sub Band 118~136MHz (AM) -3dBu 136~170MHz (FM) -14dBu 336~470MHz (FM) -14dBu *225~335.995 MHz in AM/FM may be usable although out of specification and warranty. Sensitivity is better closer to 336MHz. This band is closed at the default setting
Audio Output Power More than 100mW (8ohm)
STANDARD ACCESSORIES
  • EBP-74 Li-Ion battery pack
  • EDC-174 Drop-in charger stand
  • EA154 Whip Antenna
  • EDH-36 Dry cell case (3 AA cells)
  • EBC-23 Strap
  • User Manual
OPTIONAL ACCESSORIES
  • EDC-139: AC adapter (T/120V) for spare
  • EDC-140: AC adapter (E/230V) for spare
  • EDC-141: AC adapter (UK-plug/230V) for spare
  • EDH-33: Cigar-plug DC conversion cable (12Vdc/24Vdc to 6Vdc)
  • EDS-12: Wire Remote-controller
  • EME-26: Curly-cord Earphones
  • EME-6: Straight-cord Earphones
  • ERW-8 or ERW-16: Mini USB/USB ports PC interface cable (Full-functions)
  • ESC-50: Soft case
  • ERW-7 or ERW-15: USB Programming cable

Similar products

DJ-W70
$134.95
Quick view
DR-138MKII
$239.95
Quick view
DJ-X100E
$499.95
Quick view
DJ-X100T
$469.95
Quick view

At the same price!

DJ-W70
$134.95
 
DR-138MKII
$239.95
 
DJ-X100E
$499.95